Each kit makes three splices. Lugs are not included in kits. Feeder of 1/0 AWG-250 kcmil (60-120 sq mm), motor lead 2 AWG-250 kcmil (35-120 sq mm).3M Motor Lead Inline Splicing Kits 5300 Series are designed for splicing motor lead cables to incoming feeder cables. 3M Motor Lead Splicing Kits 5331-5334 can accommodate inline connections, 5/8 kV shielded and non-shielded feeders. The splices main component, the slip-on splice cover, is made from EPDM rubber. A mastic strip is used for the moisture seal on the inline kits. These kits are designed to be used with copper compression, one- or two-hole lugs. After being crimped onto the cables, the lugs are bolted together in an inline configuration, then insulated and sealed with the 3M Motor Lead Splicing Kits. 3M Scotchlok 30000 Series copper compression lugs, or other UL listed copper lugs, can be used (not included). Each kit contains: 3 Cold Shrink tubes, 12 adapters, 3 rolls of Scotch Stress Control Tape 2200, 3 Bags of solvent cleaning cloths, 6 tubes of silicone grease, 3 rolls of Scotch Linerless Rubber Splicing Tape 130C, 3 instruction sheets. Note: 3M Motor Lead Splice Kits 5333 require vinyl tape which can also be purchased separately.
Contains all materials required to make three splices (excluding lugs)
Easy Re-entry
Fast and simple installation
No torches or heat source needed to install
Rated for 5/8 kV applications
Thick walls to resist puncture and abrasion damage
